CB500X VentureShield Fitting

Fitting VentureShield requires a bit of patience and as long as you’ve used plenty of water/soap mix you can lift and reposition decals as required.

Required items – venture shield kit, old hair dryer, brake cleaner, clean cloths.

Thoroughly clean the bike, then spray the water/soap mixture over the panel and float the decal into place, use the rubber squeegy to remove excess water.

In places with compound curves (two directions) you can use gentle heat from the hair dryer to assist with getting around the curves, you’ll see in one photo I removed a bubble by using the pressure and heat from my thumb.

Ventureshield is a great product and my bike is as new after 4 years.